K&M 03-21-160-55 Rubber Plate

It is great that K&M offers a wide range of spare parts therefore increasing the value of their products. For example - the rubber washers which I ordered (my previous ones being over 5 years in use) keep my stands in great shape.

Don't put up with sagging stands, simple replacement with genuine part

If you have older K&M boom stands that are starting to sag even when you tighten the boom up hard, this will fix it. They do wear out in time so it's good to keep some spares around to maintain your stands. I also modified a stand and that made the boom mounting loose so an extra one of these filled the gap.

For such a basic, cheap part, it's crazy not to have them since they are so important to making your stands work properly. Now I know I can get them easily and cheaply from Thomann with my other orders I'll maintain a supply

Nice addition for microphone screws in my case

It's a rubber washer - ut does the job
Nuff said

Great spare for my K&M stands.
Works fine, easy to replace.
Much needed when stands do not tight enough.

We had at our church 3 old K&M mic stands which were not possible to use at all. The stand could not hold the angle at all.
I ordered these rubber plates and replace at all our mic stands. And they became like a brand new. After replacement we had been using them after repair already 3 years without any issues!

K&M stands out for its durability and longevity. Almost impossible to kill these mic stands. Grateful for parts like these that give them another century to survive.