Millenium Blanking Plate D Format

Drilled out to mount some BNC through-connectors into a rack panel.

These blanking plates are flat on both sides - no embossing or other moulding - so you can drill them out as required to mount other connectors that aren't otherwise supported in D-format panels. Use the Neutrik MFD mounting plates for a good strong mount of this blanking plate with your choice of connector. I used for BNCs but this approach would also work for jack sockets or RCA phono for example.

Use the Neutrik ones for a pro finish where you want a genuine blank (again use the MFD).

I went for these over the Neutrik ones, and I'm glad I did. They're cheaper, made from plastic, but since they're just a blanking panel, they don't need to be anything else, and when mounted from the back, it's completely flush with the panel itself, giving a nice, clean look.

Aussi bien que les vrais !

The covers are clean, no branding, no text.
Makes the blanking plate look clean especially when rear mounted.
It would be nice if screws were included.

Basic, black, plastic, correctly sized. Rigid enough that you could drill out a hole to mount a smaller connector if required.