Med vores cookies ønsker vi at tilbyde dig den bedst mulige shoppingoplevelse med alt, hvad der hører til. Dette inkluderer for eksempel passende tilbud, personlige annoncer og gemte præferencer. Hvis du er okay med dette, skal du blot acceptere brugen af cookies til præferencer, statistik og markedsføring ved at klikke på "I orden!" (vis alle). Du kan til enhver tid trække dit samtykke tilbage via cookie-indstillingerne (her)
Du skal være logget på, for at kunne vurdere et produkt.
BemærkVi tillader kun vores kunder, at afgive en vurdering af det udstyr de har købt hos os. Vi modtager ikke anmeldelser eller vurderinger af produkter fra tredje kilde.
Efter login finder du også i kundencenter under "vurderinger af produkt" alle artikler, som du kan afgive en vurdering af.
Good quality cable that has issue when soldering with lead-free solder
leonlag 08.11.2025
The inner conductor insulation cannot withstand the temperatures used used to solder lead-free solder(300C). It's not that big of a deal when soldering the invidual wires since you can simply heat up the contact on the connector and then quickly dip the conductor into the molten solder. The issue is more noticeable when trying to solder the shield as that is obviously wound around the individual conductors and can sink quite a bit of head due to it's bigger diameter.
Soldering this with lead-free solder is definitely doable but I wouldn't buy this again for this reason and would rather look for something with silicone insulation around the conductors.
Good quality and good sounding cable for independent 3 wire XLR plus additional shielding. The shield is very good quality. I measured the capacity for my 5 meter cables. The capacity between the active wires is about 370pF and the shield to active about 600pF. This gives about 1 degree phase error in 20kHz and the frequency start slight to roll off after the 70kHz range.