Med vores cookies ønsker vi at tilbyde dig den bedst mulige shoppingoplevelse med alt, hvad der hører til. Dette inkluderer for eksempel passende tilbud, personlige annoncer og gemte præferencer. Hvis du er okay med dette, skal du blot acceptere brugen af cookies til præferencer, statistik og markedsføring ved at klikke på "I orden!" (vis alle). Du kan til enhver tid trække dit samtykke tilbage via cookie-indstillingerne (her)
Du skal være logget på, for at kunne vurdere et produkt.
BemærkVi tillader kun vores kunder, at afgive en vurdering af det udstyr de har købt hos os. Vi modtager ikke anmeldelser eller vurderinger af produkter fra tredje kilde.
Efter login finder du også i kundencenter under "vurderinger af produkt" alle artikler, som du kan afgive en vurdering af.
I have a cheaper K&M mic stand that had a smaller plastic nut that was hard to tighten properly. This is a perfect replacement for it! Very easy to rotate! May be good for other stands too that have a 8mm bolt.
I've got about 15 Mic stands in the studio, and some of them had a smaller capstan head for the mechanism that tightens the boom arm, so I replaced the smaller ones with these. because I can keep the microphone leads rolled up on the mike stand and hang them over this type of Capstan. So I don't have to Keep the leads anywhere else, they are all on the mic stands ready to go, and that saves me a lot of time.
Do you own a K&M microphone stand that has the small plastic capstan?
Do you almost break your hand everytime you tighten up the main joint?
Then this is for you!