Til sidens indhold

Adjustable Microphone Arm

  • With holder
  • For D-, V-, M- and S-stands
  • Black model
  • Length: 840 mm
  • With 3/8" connection thread, locking washer and handle
  • Secure clamping
  • A plastic sleeve protects tube from scratches
  • With holder to insert the arm into a vertical tube of the stand
  • Fås siden December 2005
  • Artikelnummer 187594
  • salgsenhed 1 stk
  • Type Of Keyboard Stand Microphone Boom
  • Colour Black
379 kr
Alle priser inkl. moms
på lager
1

16 Kundebedømmelser

4.5 / 5

stabilitet

forarbejdning

10 Anmeldelser

google translate gb
Der opstod en fejl. Prøv igen senere.
M
A little assembly advice
Matlow 07.02.2023
Great product, just little to no instructions. Therefore for those struggling a little - I used a sharp butchers knife to prise the cap off the vertical bar (you need something sharp to get between the cap and the bar), then used a mallet to get the boom arm stopper wedged in properly. Then tighten the nut on the stopper with a spanner, place the cap over the thread/nut, slide the boom arm out of the holder and screw the holder to the stopper as tight as it’ll go, then it’ll rotate smoothly with a bit of torque force from the reattached boom arm. Job done.
stabilitet
forarbejdning
2
0
Anmeld bedømmelse

Anmeld bedømmelse

google translate gb
Der opstod en fejl. Prøv igen senere.
MG
Works as Advertised but a bit short
M Gho 30.11.2020
I am using it with my Jaspers 2D-145B which is designed for 88 keys. At this width, the microphone arm is positioned around 1.5 Octave above middle C on my RD 700. If you place it on the smaller Jaspers stand, it should be positioned exactly in the middle
stabilitet
forarbejdning
1
0
Anmeld bedømmelse

Anmeld bedømmelse